How to Install a Lever Handle on a Door
In this locksmith instructional video we show you how to install a lever door handle. Need to have the locks changd or rekeyed on your homes exterior doors? In Mesa and throughout the Metro Phoenix area, call us day or night at (480) 418-7560https://locksmith-near-me-mesa-arizona.com/residential-locksmith/how-to-install-a-lever-handle-on-a-door/Posted by Locksmith Near Me in Mesa on Thursday, May 3, 2018
Door Lever Handle Installation
What we have here is an entry-level set and a deadbolt. We have the lever set with a thumb turn and lock. This will obviously go on the outside, this will go on the inside and locking deadbolt inside and outside. Single-sided so it only takes a key on one side. And we're going to install it in the practice door. This is the latch. In this instance we're going to install this as though it's a right-handed door so the door is going to close that way. So this obviously needs to go in this direction so that the door is prevented from opening by this latch on the flat side. So that will go in first. We fasten the latch into the door using the two screws provided. Now with this half moon shape, in this particular brand, that's going to go inside, this is our lock it lockable side, that's going to go on the outside and this has to match up with the same shape there. And in order to insert that we need to push that slightly inward. Slide it in and then the two fasteners match there. Then we install the lever. And again, that has a matching half moon on this side to match up with this side and then the little white knob in the center is going to be inserted into this tail piece. And as you can see this is designed with a with a space here that covers the screw hole, so rather than fighting this we're just going to take this off with the provided allen wrench. Take this off for now out of our way. We're going to line this up to where this half moon and that button line up with the tail piece and this actuator here. And now we're going to install the lever and tighten it down with the allen wrench.